# Nginx not installed after running succesfully "vagrant up"

**URL:** https://discourse.roots.io/t/nginx-not-installed-after-running-succesfully-vagrant-up/13459
**Category:** trellis
**Created:** 2018-08-27T12:51:34Z
**Posts:** 5

## Post 1 by @odelweb — 2018-08-27T12:51:34Z

Hi, I´ve followed the documentation to install trellis on a local linux machine, and after running “vagrant up” I get a success message:  
==\> default: Your Trellis Vagrant box is ready to use!  
and some info about vagrant ssh and the location of Wordpress sites.

The next thing I do is trying to open my brand new wordpress installation on my browser, to no avail. I checked my /etc/hosts to make sure I was entering the right url.

Then I run “vagrant ssh” and I search for the wordpress files. And /srv is an empty folder. Also I check the nginx status, and to my surprise, it isn´t an existing service on the VM.

Then I run apt-get install nginx, and I can see its welcome page on [http://192.168.50.5/](http://192.168.50.5/) but /srv/ is still an empty folder, and I am a bit lost. Wasn’t nginx supposed to be already up and running? What do I do now to get a wordpress site running on trellis?

I´ve got ansible 2.6.3, virtualbox 5.1.38 and vagrant 2.1.2 installed. Thanks

---

## Post 2 by @MWDelaney — 2018-08-27T13:01:17Z

Hi,  
It sounds like maybe you didn’t install Bedrock. See the documentation here, specifically bullet 3, “Clone Bedrock”:

> **[Installing Trellis | Trellis Documentation | Roots](https://roots.io/trellis/docs/installing-trellis/)**
>
> Before installing Trellis the requirements must be met. After installing Ansible, Virtualbox, and Vagrant, setup your Trellis directory structure.

---

## Post 3 by @odelweb — 2018-08-27T13:07:02Z

hi, thanks for the early reply. I have installed Bedrock. I did clone both trellis and bedrock from the github repository, and on my host machine bedrock is within a folder called “site”. Folder and files permissions are similar to those on the trellis folder, and are owned by the same user, the one who run vagrant up.

---

## Post 4 by @MWDelaney — 2018-08-27T13:24:46Z

Can you try a `vagrant destroy && vagrant up` and watch for errors during the process?

What operating system are you using on your host?

---

## Post 5 by @odelweb — 2018-08-27T14:46:04Z

It works!  
I´m using linux mint. Apparently it was a firewall issue. When trying the `vagrant destroy && vagrant up` I would get a time out error when mounting nfs. After disabling the firewall that error didn´t show again, and the whole lemp stack got installed. But yet I could not access my brand new wordpress installation on my browser. A new `vagrant destroy && vagrant up` made it work. I got some warnings, related to ansible version being too new tho.

Thanks MWDelaney for your support. Now I need to figure out how to configure my firewall, but that seems out of the scope of this forum. Cheers